2gig PIR1-345 Bedienungsanleitung PDF herunterladen

PASSIVE INFRARED MOTION DETECTOR

FCC ID: WDQ-PIR1345

Industry Canada ID: 7794A-PIR1345

INSTALL INSTRUCTIONS

ThePassiveInfraredMotionDetectorisawall‐mountedunitwithwide

anglemotionprotection.WhensettoHighSensitivityMode,thePassive

InfraredMotionDetector(PIR)hasamaximumrangeof30feetdeepx50

feetwide. ThePIRispetimmuneupto55lbs.

Box Contents

•Detector

•3VLithiumbattery

•3screwsand2dowels

•Bracket

•Flatwallmount

•Cornermount

Programming

Thefollowingstepsdescribegeneralguidelinesforprogramming

(learning)thePIRintotheControlPanel.Scrollbetweenoptionsusingthe

←and→arrows.Movetothepreviousornextpromptbypressingthe↑

and↓arrows.

1 SelectRFsensor#(01to48).AssignthePIRtoanewzone.

2 SelectRFsensortype:

(04)interiorfollower

(10)int

eriorwithdelay

3 SelectRFsensorequipmentcode.Enter0533forthePassiveInfrared

MotionDetector.

4 SelectRFequipmenttype.

(2)moti

5 EnterRFsensorserialnumber(7digits).

ManualEntry:Typeinthelast7digitsoftheTXIDthatisfound

outsideoftheboxoronthebackofthedevice.

AutoEntry:WiththepanelinLearn‐inmode,(pressShiftthenLearn)

pressthetamperswitch.ThecorrectTXIDshouldap

pear.Acceptthe

correctTXIDbypressingok.

Remembertopr

essthe↓arrowtocontinuegoingthroughthe

systemconfigurationprompts.

6 SelectRFsensorequipmentage(0to1).

(0)new(

productisnew)

(1)ex

isting(productalreadyexists)

7 SelectRFsensorloopnumber(1to3).

8 SelectRFSensordialerdelay(0to1)

(0)disable

(1)ena

bled

9 ConstructRFsensorvoicedescriptor.PressInsertthenpressany

numberbetween002and255toaddaword.Repeatthisforeach

word.Forexample,ifyouwanttonamethisPIRasthe“master

bedroom,”pressInsertthenpress140formaster.PressInsertthen

press024forbedroom.

10 SelectRFsensorreports(0to1).

(0)disable

d(PIRdoesnotreporttothecentralstation)

(1)ena

bled(PIRreportstothecentralstation)

11 SelectRFsensorsupervised(0to1)

(0)disable

d(detectordoesnotreportlossofsupervision/lowbattery)

(1)ena

bled(detectorreportslossofsupervision/lowbattery)

12 SelectRFsensorchime(0to13).

(0)disable

d(panelwillNOTchimewhenPIRisactivated)

(1‐13

)enabled(selectsavoiceandchimetosoundonthepanelwhen

thePIRisactivated)

13 Toprogramanothersensorclicknext.

14 Toexitprogramming,clickskipthenendandexit.Uponexit,the

paneltakesseveralsecondstoreboot.

Testing

Beforemountingthedetector,ensurethatthePIRmountinglocation

providesgoodRFcommunicationtothepanel.Toverify,dothefollowing:

1 FromtheInstallerToolbox,selectwalktest.

2 PlacetheamagnetoverthearrowontheleftsideofthePIR,(the

detector’sLEDindicatesthatamagnethasbeendetected)andthen

removethemagnet(amagnetisnotsupplied).

3 PlacethePIRinthelocationthatyouplanonmountingit.

4 MoveintheareathatistobecoveredbythePIRandmakesurethat

theLEDonthePIRflasheseverytimeyoumove.TheLEDflashing

continuesfor1minutesoyoucancheckthePIRbeamcoverage.

NOTE: Thereisa3‐seconddelaybetweenflashesontheLED.

IMPORTANT: Thefollowingcancauseafalsealarmwhentesting:

•Leavingthecoveroff

•Removingjumpers

• PositioningthePIRindirectsunlightorcloseproximitytoaheatingor

anairconditioningduct

5 Exitinstallertoolbox.

Inserting and Replacing Batteries

IfasupervisedPIRbatteryislow,alowbatterynotificationisindicatedon

theControlPanel’ stouchscreen.Ifindicated,replacethebattery

immediately.Useonlytherecommendedreplacementbatteries(See

Specifications).

•Removebackcoverbyunscrewingbottomscrewandpullbackcover

frombottomtotop.Observethepolarityofthebat

tery.SeeFigure2.

WARNING: Improperhandlingoflithiumbatteriesmayresultinheat

generation,explosionorfire,resultinginpersonalinjuries.

Replaceonlywiththesameorequivalenttypeofbatteryas

recommendedbythemanufacturer(seeSpecifications).

Batteriesmustnotberecharged,disassembledordisposedofinfire.

Disposalofusedbatteriesmustbemadeinac

cordancewiththe

wasterecoveryandrecyclingregulationsinyourarea.KeepAway

FromSmallChildren.Ifbatteriesareswallowed,promptlyseek

medicalattention.

CaliforniaOnly:ThisPerchloratewarningappliesonlytoManganese

DioxideLithiumcellssoldordistributedONLYin/California,U.S.A.

PerchlorateMaterial‐specialhandlingmayapply.Seedt

sc.ca.gov/

hazardouswaste/perchlorate.

Installing and Mounting

RemovethescrewfromthebottomofthecaseandopenthePIR(see

Figure1).

1 Installthe3VLithiumbatteryfromthebox.

2 Settheleftjumper(PETIMMUNITY)toeither33lbs.(15kg)or55lbs.

(25kg;default).(seeFigure2)

3 Settherightjumper(SENSITIVITY)toeitherLO(default)orHI(see

Figure2).

4 Pressandreleasethetamperswitchtobeginthepowerupprocess.

5 Wait10secondsforthePIRtofullypowerup.

1 2

Inhaltsverzeichnis

Seite 1 - INSTALL INSTRUCTIONS

PASSIVE INFRARED MOTION DETECTORFCC ID: WDQ-PIR1345Industry Canada ID: 7794A-PIR1345INSTALL INSTRUCTIONSThePassiveInfraredMotionDetectorisawall

Seite 2 - Using the PIR with Pets

Mounting the PIR with the bracket (see Figure 2)1 UseshortPhillipsheadscrewstoscrewpartAintopartB.2 Selecteitherthecornermount(partC)

Kommentare zu diesen Handbüchern

Keine Kommentare

2gig PIR1-345 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Zuhause 2gig PIR1-345 herunter. 2GIG PIR1-345 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Zuhause 2gig PIR1-345